Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › QUARTER PILLAR COVER(for Hatchback) › from 2017.10
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0118074 QUARTER PILLAR COVER(for Hatchback) A

EXTERIOR PANELS / TRIM  QUARTER PILLAR COVER(for Hatchback)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75554E 1.INSTALL QUARTER GARNISH MOULDING

HINT:

When installing the quarter garnish moulding, heat the quarter pillar cover sub-assembly using a heat light.


CAUTION:
·
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.

Standard:
Item Temperature
Quarter Pillar Cover Sub-assembly 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the quarter pillar cover sub-assembly excessively.




a.

Clean the quarter garnish moulding installation surface with a non-residue solvent.


b.

Apply primer to the quarter garnish moulding installation area on the quarter pillar cover sub-assembly.

NOTICE:

Apply primer evenly so that there are no uncoated areas.



c.

Remove the peeling paper on a new quarter garnish moulding while making sure not to touch the adhesive surface.


d.
B484317

Install the quarter garnish moulding as shown in the illustration.

NOTICE:
·

Press the double-sided tape on the quarter garnish moulding firmly to ensure proper adhesion.

·

After the primer dries (3 minutes or more), install the quarter garnish moulding.

·

After applying primer, reapply primer after 24 hours elapse.




Hide 62506C 2.INSTALL QUARTER PILLAR COVER SUB-ASSEMBLY

a.
B484316

Install the 6 new clips.

HINT:

When reusing the quarter pillar cover sub-assembly, replace the 6 clips with new ones.



b.
B484318

Engage the 6 clips and install the quarter pillar cover sub-assembly.


c.

Remove the protective tape.