Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR(for TMMIN Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017123 MIRROR (EXT) _0336648 OUTER REAR VIEW MIRROR(for TMMIN Made) A

MIRROR (EXT)  OUTER REAR VIEW MIRROR(for TMMIN Made)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 87940 1.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY (w/ Power Mirror Adjust Function)

a.

Engage the 2 guides and the claw, and temporarily install the outer rear view mirror assembly.


b.

Temporarily install the 3 screws.

NOTICE:

If reusing the outer rear view mirror assembly, make sure the screws are not tilted and the screw threads are aligned with the threads of the mirror when temporarily tightening them in order to prevent damage to the threads.



c.

Tighten the 3 screws and install the outer rear view mirror assembly.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

Overtightening the outer rear view mirror assembly can strip the threads and cause the mirror to fall off, so make sure the tightening torque is less than 11 N*m (112 kgf*cm, 8 ft.*lbf).

·

If reusing the outer rear view mirror assembly, do not retighten the screws more than 2 times (each screw hole of the outer rear view mirror assembly can only be tightened a total of 3 times).




d.

Install the clip.


e.

Connect the connector.


Hide 87940 2.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY (w/o Power Mirror Adjust Function)

a.

Engage the 2 guides and the claw, and temporarily install the outer rear view mirror assembly.


b.

Temporarily install the 3 screws.

NOTICE:

If reusing the outer rear view mirror assembly, make sure the screws are not tilted and the screw threads are aligned with the threads of the mirror when temporarily tightening them in order to prevent damage to the threads.



c.

Tighten the 3 screws and install the outer rear view mirror assembly.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

Overtightening the outer rear view mirror assembly can strip the threads and cause the mirror to fall off, so make sure the tightening torque is less than 11 N*m (112 kgf*cm, 8 ft.*lbf).

·

If reusing the outer rear view mirror assembly, do not retighten the screws more than 2 times (each screw hole of the outer rear view mirror assembly can only be tightened a total of 3 times).




d.

Install the clip.


Hide 67602 3.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74232 4.INSTALL FRONT ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74232 5.INSTALL FRONT ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 69260 6.INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 67492A 7.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH