Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY(for TMT Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0336762 FOG LIGHT ASSEMBLY(for TMT Made) A

LIGHTING (EXT)  FOG LIGHT ASSEMBLY(for TMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 53876A 1.SEPARATE FRONT FENDER LINER

a.
E375248C01
1.292,3.26 0.948,3.667 true 1.802,3.146 2.427,2.969 true 2.479,2.875 2.792,3.031 0.313,0.156 10 false *1 0.854,3.656 1.167,3.813 0.313,0.156 10 false *a
*1 Pin Hold Clip
*a Protective Tape


Using a screwdriver wrapped with protective tape, disengage the 2 claws and remove the pin hold clip.


b.

Remove the clip.


c.
E270943

Remove the 3 screws and separate the front side of the front fender liner.


Hide 81220 2.REMOVE FOG LIGHT ASSEMBLY

a.
E373767

Disconnect the connector.


b.

Remove the 3 screws and remove the fog light assembly.