Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
81562A
1.REMOVE REAR COMBINATION LIGHT GASKET
Remove the rear combination light gasket.
Be sure to remove all the traces of the old rear combination light gasket from the body.
Do not reuse the removed rear combination light gasket. Be sure to install a new rear combination light gasket to prevent water ingress.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and separate them as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
81550H
3.REMOVE TAIL AND STOP LIGHT BULB (for Bulb Type Stop Light)
Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration, and separate them as a unit.
Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.
81565
4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for LED Type Stop Light)
Disconnect the connector to remove the rear combination light socket and wire sub-assembly.
81555
5.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for Bulb Type Stop Light)
Disengage the 2 clamps to remove the rear combination light socket and wire sub-assembly.