Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY(for Sedan with Rear Light) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0336766 REAR COMBINATION LIGHT ASSEMBLY(for Sedan with Rear Light) A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY(for Sedan with Rear Light)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81555 1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for Bulb Type Stop Light)

a.
E375251

Engage the 2 clamps to install the rear combination light socket and wire sub-assembly.


Hide 81565 2.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for LED Type Stop Light)

a.
E374551

Connect the connector to install the rear combination light socket and wire sub-assembly.


Hide 81550H 3.INSTALL TAIL AND STOP LIGHT BULB (for Bulb Type Stop Light)

a.

Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly.


b.
E375250

Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.


Hide 81550L 4.INSTALL REAR TURN SIGNAL LIGHT BULB

a.
E374555

Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.


b.
E374553

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb inthe direction indicated by the arrow shown in the illustration to install them as a unit.


Hide 81562A 5.INSTALL REAR COMBINATION LIGHT GASKET

a.
E374549

Install a new rear combination light gasket.

NOTICE:
·

Be sure to remove all the traces of the old rear combination light gasket from the body.

·

Do not reuse the removed rear combination light gasket. Be sure to install a new rear combination light gasket to prevent water ingress.