Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
81594A
1.REMOVE REAR LIGHT GASKET
Remove the rear light gasket.
Be sure to remove all the traces of the old rear light gasket from the body.
Do not reuse the removed rear light gasket. Be sure to install a new rear light gasket to prevent water ingress.
81550N
2.REMOVE BACK UP LIGHT BULB
Turn the rear light socket and wire with the back up light bulb in the direction indicated by the arrow shown in the illustration, and separate them as a unit.
Remove the back up light bulb from the back up light socket.
81585C
3.REMOVE REAR LIGHT SOCKET AND WIRE
for LED Type Stop Light:
Disconnect the connector.
Disengage the claw and clamp, remove the rear light socket and wire.
for Bulb Type Stop Light:
Disengage the claw and 2 clamps, remove the rear light socket and wire.