Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
81585C
1.INSTALL REAR LIGHT SOCKET AND WIRE
for LED Type Stop Light:
Engage the claw and clamp, install the rear light socket and wire.
Connect the connector.
for Bulb Type Stop Light:
Engage the claw and 2 clamps, install the rear light socket and wire.
81550N
2.INSTALL BACK UP LIGHT BULB
Install the back up light bulb into the back up light socket.
Turn the rear light socket and wire with the back up light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.
81594A
3.INSTALL REAR LIGHT GASKET
Install a new rear light gasket.
Be sure to remove all the traces of the old rear light gasket from the body.
Do not reuse the removed rear light gasket. Be sure to install a new rear light gasket to prevent water ingress.