88460
1.INSTALL COOLER CONDENSER ASSEMBLY
Engage the 2 guides to install the cooler condenser assembly to the vehicle as shown in the illustration.
Engage the 2 claws.
Do not damage the cooler condenser assembly or radiator assembly when installing the cooler condenser assembly.
If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows.
Add 40 cc (1.35 fl. oz.)
ND-OIL 8 or equivalent.
88706A
2.CONNECT LIQUID TUBE SUB-ASSEMBLY A
Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.
ND-OIL 8 or equivalent.
Install the O-ring onto the liquid tube sub-assembly A.
Install the liquid tube sub-assembly A onto the cooler condenser assembly with the bolt.
88711
3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.
ND-OIL 8 or equivalent
Install the O-ring to the No. 1 cooler refrigerant discharge hose.
Install the No. 1 cooler refrigerant discharge hose onto the cooler condenser assembly with the bolt.
53216A
4.INSTALL UPPER RADIATOR SUPPORT
88891H
5.INSTALL NO. 1 COOLER COVER
53208A
6.INSTALL HOOD LOCK SUPPORT
53510
7.INSTALL HOOD LOCK ASSEMBLY
89173
8.INSTALL FRONT AIRBAG SENSOR
81150
9.INSTALL HEADLIGHT ASSEMBLY LH
81110
10.INSTALL HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
11.ADJUST HOOD SUB-ASSEMBLY
12.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
13.WARM UP ENGINE
14.INSPECT FOR REFRIGERANT LEAK