Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(for TMMIN Made) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0336782 CONDENSER(for TMMIN Made) A

HEATING / AIR CONDITIONING  CONDENSER(for TMMIN Made)  INSTALLATION  


PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

a.
I109789

Engage the 2 guides and install the cooler condenser assembly to the vehicle as shown in the illustration.


b.

Engage the 2 claws.

NOTICE:

Do not damage the cooler condenser assembly or radiator assembly when installing the cooler condenser assembly.


HINT:

If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows.


Capacity:

Add 40 cc (1.35 fl. oz.)


Compressor oil:

ND-OIL 8 or equivalent.



Hide 88706A 2.CONNECT LIQUID TUBE SUB-ASSEMBLY A

a.

Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.


b.

Apply sufficient compressor oil to a new O-ring and fitting surface of the tube joint.

Compressor oil:

ND-OIL 8 or equivalent.



c.

Install the O-ring onto the liquid tube sub-assembly A.


d.

Install the liquid tube sub-assembly A onto the cooler condenser assembly with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 88711 3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.


b.

Apply sufficient compressor oil to a new O-ring and fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the No. 1 cooler refrigerant discharge hose.


d.

Install the No. 1 cooler refrigerant discharge hose onto the cooler condenser assembly with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 53216A 4.INSTALL UPPER RADIATOR SUPPORT

Hide 88891H 5.INSTALL NO. 1 COOLER COVER (w/ No. 1 Cooler Cover)

Hide 53215B 6.INSTALL HOOD LOCK SUPPORT

Hide 53510 7.INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

Hide 53510 8.INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

Hide 81150 11.INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 53301 12.INSPECT HOOD SUB-ASSEMBLY

Hide 53301 13.ADJUST HOOD SUB-ASSEMBLY

Hide 14.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT