55900
1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY (HAZARD WARNING SIGNAL SWITCH ASSEMBLY)
Check the resistance.
| *a | Component without harness connected
(Air Conditioning Control Assembly (Hazard Warning Signal Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3(TB) - 8(GND) | OFF | 10 kΩ or higher |
| ON | Below 1 Ω |
If the result is not as specified, replace the air conditioning control assembly (hazard warning signal switch assembly).