Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR › from 2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0259846 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
B157083C89
1.521,0.333 1.896,0.573 0.375,0.24 0.99,1.583 1.438,1.167 true 1.573,1.583 1.604,1.198 true 0.135,0.104 0.344,0.26 0.208,0.156 10 false *a 1.635,0.375 1.969,0.771 0.333,0.396 10 false E2 0.75,1.625 1.156,1.792 0.406,0.167 10 false CLTB 1.438,1.625 1.844,1.792 0.406,0.167 10 false CLTE
*a Front view of wire harness connector
(to Automatic Light Control Sensor)


Disconnect the E1 automatic light control sensor connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E2-1 (CLTB) - E2-2 (CLTE) Ignition switch off Below 1 V
E2-1 (CLTB) - E2-2 (CLTE) Ignition switch ON 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
E2-2 (CLTE) - Body ground Always Below 1 Ω


If the result is not as specified, there may be a malfunction on the wire harness side.


c.
E259758C92
1.531,0.271 1.938,0.521 0.406,0.25 1.833,1.177 2.385,0.885 true 1.458,1.167 0.896,0.896 true 0.188,0.135 0.438,0.313 0.25,0.177 10 false *a 1.656,0.313 1.948,0.698 0.292,0.385 10 false E2 0.542,0.771 0.958,0.948 0.417,0.177 10 false CLTS 2.438,0.792 2.833,0.958 0.396,0.167 10 false CLTE
*a Component with harness connected
(Automatic Light Control Sensor)


Reconnect the E1 automatic light control sensor connector.


d.

Connect an oscilloscope to the automatic light control sensor connector.


e.
E276298N01
2.844,1.646 3.219,1.813 0.375,0.167 10 false GND

Check the waveform.

OK:
Tester Connection Tool Setting Condition Specified Condition
E2-4 (CLTS) - E1-2 (CLTE) 2 V/DIV., 10 ms./DIV. Ignition switch ON, light control switch in AUTO position Correct waveform is as shown


HINT:

The communication waveform changes according to the surrounding brightness.


If the result is not as specified, the automatic light control sensor may be malfunctioning.