Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.
76801
1.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81270
2.REMOVE LICENSE PLATE LIGHT ASSEMBLY
Disconnect the connector.
Disengage the 2 claws and remove the license plate light assembly.
81274B
3.REMOVE LICENSE PLATE LIGHT PACKING
Remove the license plate light packing.
Do not reuse the removed license plate light packing. Be sure to install a new license plate light packing to prevent water ingress.
81271
4.REMOVE LICENSE PLATE LIGHT LENS
Disengage the 2 claws to remove the license plate light lens.
81270B
5.REMOVE LICENSE PLATE LIGHT BULB
Remove the license plate light bulb from the license plate light housing.