FREEZE FRAME DATA
Using the GTS, check the vehicle condition (ECU, sensor) when the brake system operates or a DTC is output.
CHECK FREEZE FRAME DATA WHEN BRAKE SYSTEM OPERATES
Freeze frame data is stored when the brake system operates. The freeze frame data is updated each time the system operates.
Once freeze frame data is stored when the system operates, it is not cleared until the DTC is cleared.
The number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the system was activated can be stored and displayed.
When the vehicle is stopped (vehicle speed below 7 km/h (4.3 mph)), turning the ignition switch from off to ON does not cause the value to increase.
The value "31" is displayed when the ignition switch was turned to ON more than 31 times.
Check freeze frame data when the system operates
Turn the ignition switch off.
Connect the GTS to the DLC3 and turn the ignition switch to ON.
Enter the following menus: Chassis / ABS/VSC/TRC / Utility.
Select "ABS History".
| Tester Display |
|---|
| ABS History |
Check the freeze frame data when the system operates.
CHECK FREEZE FRAME DATA WHEN DTC WAS STORED
Freeze frame data is stored when a DTC is output.
Once freeze frame data is stored when a DTC is output, it is not updated or cleared until the DTC is cleared.
The number of times (maximum: 31) the ignition switch has been turned from off to ON since a DTC was output can be stored and displayed.
The value "31" is displayed when the ignition switch was turned to ON more than 31 times.
Check freeze frame data when DTC is output
Turn the ignition switch off.
Connect the GTS to the DLC3 and turn the ignition switch to ON.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Select a DTC to display the freeze frame data.
Check the freeze frame data for the output DTC.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Elapsed Time after Freeze Trigger | Elapsed time after freeze trigger | Min.: 0 msec, Max.: 500 msec | - | - |
| Number of IG ON | Number of times ignition switch turned to ON after Freeze Frame Data stored | 0 to 31 | - | - |
| Stop Light SW | Stop light switch | ON or OFF | ON: Brake pedal depressed
OFF: Brake pedal released |
- |
| Parking Brake SW | Parking brake switch | ON or OFF | ON: Parking brake applied
OFF: Parking brake released |
- |
| Shift Lever Position | Shift lever position information | P, N, R, D/M, 1st-6th/B or Fail | Actual shift lever position | - |
| Operated System | Operated system status | ABS, VSC, TRC, BA, HAB, PBA, PB, HA-CTRL, TSC, Fail, Sys or Non | Actual operated system | ABS: ABS activated
VSC: VSC activated TRC: TRC activated BA: BA activated HAB: High power assist brake activated* PBA: PBA activated* PB: PB activated* HA-CTRL: Hill-start assist control activated* TSC: Trailer sway control activated* Fail: Fail-safe mode activated Sys: System prohibit activated Non: No operation activated |
| Master Cylinder Sensor | Master cylinder pressure sensor reading | Min.: 0.00 V, Max.: 5.00 V | Brake pedal released: 0.30 to 0.80 V | Reading increases when brake pedal is depressed |
| M/C Sensor Grade | Master cylinder pressure sensor change | Min.: -30 MPa/s, Max.: 225 MPa/s | Brake pedal released or pedal held at constant position: 0 MPa/s | When brake pedal is being operated: Changes in proportion with pedal movement speed |
| Yaw Rate Sensor | Yaw rate sensor | Min.: -128°/s, Max.: 127°/s | Vehicle stopped: 0°/s
Turning right: -128 to 0°/s Turning left: 0 to 127°/s |
- |
| Lateral G | Lateral G | Min.: -25.10 m/s2, Max.: 24.90 m/s2 | - | During turning: Changes in proportion with lateral acceleration |
| Forward and Rearward G | Forward and backward G | Min.: - 25.10 m/s2, Max.: 24.90 m/s2 | - | During acceleration/deceleration: Changes in proportion with acceleration |
| FR Wheel Speed | Front wheel speed sensor RH reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| FL Wheel Speed | Front wheel speed sensor LH reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| RR Wheel Speed | Rear wheel speed sensor RH reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| RL Wheel Speed | Rear wheel speed sensor LH reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Vehicle Speed Grade | Vehicle speed grade | Min.: -25.10 m/s2, Max.: 24.90 m/s2 | Vehicle stopped: 0.00 m/s2 | During driving: Changes in proportion with vehicle acceleration/deceleration |
| Real Engine Torque | Real engine torque | Min.: -1024.0 Nm, Max.: 1023.0 Nm | - | - |
| Accelerator Opening Angle % | Percentage of accelerator pedal opening angle | Min.: 0.0%, Max.: 128.0% | Accelerator pedal released: 0.0% | During accelerator pedal operation: Changes in proportion with the pedal movement |
| IG1 Voltage Value | IG1 voltage value | Min.: 0.00 V, Max.: 20.00 V | Ignition switch to ON: 11.00 to 14.00 V | - |
| Inspection Mode | Inspection mode | Other or Inspect | Other: Normal mode
Inspect: Inspection mode |
- |
| Steering Angle Sensor | Steering angle sensor | Min.: - 3276.8°, Max.: 3276.7° | Turning left: Increases
Turning right: Decreases |
- |
| TRC/VSC Off Mode | TRC/VSC off mode | Normal, TRC OFF or VSC OFF | Normal: Normal mode
TRC OFF: TRC off mode VSC OFF: VSC off mode |
- |
*: Not supported
CLEAR FREEZE FRAME DATA
Clearing the DTC will also clear the Freeze Frame Data.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Clear the DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR