Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092618 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY (for LED Type Stop Light)

a.
E248380C27
1.448,0.208 1.896,0.479 0.448,0.271 1.365,1.792 1.365,1.292 true 1.708,1.792 1.708,1.292 true 2.063,1.792 2.063,1.292 true 0.135,0.135 0.448,0.333 0.313,0.198 10 false *a 1.542,0.26 2,0.458 0.458,0.198 10 false A56 1.323,1.813 1.479,2.01 0.156,0.198 10 false B 1.563,1.813 1.917,2.052 0.354,0.24 10 false GND 2.021,1.813 2.177,2.01 0.156,0.198 10 false B
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


Disconnect the stop light switch assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A56-1 (B) - A56-3 (GND) Always 11 to 14 V
A56-5 (B) - A56-3 (GND) Ignition switch ON 11 to 14 V
A56-5 (B) - A56-3 (GND) Ignition switch off 0 V


Standard Resistance:
Tester Connection Switch Condition Specified Condition
A56-3 (GND) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the wire harness or connector.


c.

Reconnect the stop light switch assembly connector.


d.
E248381C24
1.521,0.167 1.917,0.417 0.396,0.25 1.885,1.323 2.25,1.667 true 1.719,1.333 1.25,1.667 true 2.156,1.698 2.615,1.896 0.458,0.198 10 false OUT 1.083,1.688 1.542,1.885 0.458,0.198 10 false GND 1.594,0.219 2.052,0.417 0.458,0.198 10 false A56 0.104,0.083 0.417,0.281 0.313,0.198 10 false *a
*a Component with harness connected
(Stop Light Switch Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A56-2 (OUT) - A56-3 (GND) Ignition switch off, brake pedal not depressed Below 1 V
A56-2 (OUT) - A56-3 (GND) Ignition switch off, brake pedal depressed 11 to 14 V


If the result is not as specified, replace the stop light switch assembly.