Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092618 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY (for Bulb Type Stop Light)

a.

Check the resistance.

i.
E272778C01
0.438,0.979 0.51,0.583 false 0.052,1.323 0.365,1.521 0.313,0.198 10 false *b 0.583,1.344 0.896,1.542 0.313,0.198 10 false *c 0.469,0.417 0.781,0.615 0.313,0.198 10 false *1 2.01,0.26 2.323,0.458 0.313,0.198 10 false *a
*1 Switch Pin
*a Component without harness connected
(Stop Light Switch Assembly)
*b Not Pushed
*c Pushed


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Switch pin pushed 10 kΩ or higher
Switch pin not pushed Below 1 Ω
3 - 4 Switch pin pushed Below 200 Ω
Switch pin not pushed 10 kΩ or higher


If the result is not as specified, replace the stop light switch assembly.