DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Driver Side Door | Front door courtesy switch signal (driver side) | CLOSE or OPEN | CLOSE: Driver side door is closed
OPEN: Driver side door is opened |
- |
| Passenger Side Door | Front door courtesy switch signal (passenger side) | CLOSE or OPEN | CLOSE: Passenger side door is closed
OPEN: Passenger side door is opened |
- |
| Rear Left Side Door | Rear door courtesy switch signal (LH side) | CLOSE or OPEN | CLOSE: Rear LH door is closed
OPEN: Rear LH door is opened |
- |
| Rear Right Side Door | Rear door courtesy switch signal (RH side) | CLOSE or OPEN | CLOSE: Rear RH door is closed
OPEN: Rear RH door is opened |
- |
| Door All (Except for Driver Side Seat) | Door courtesy switch (except for driver side seat) signal | CLOSE or OPEN | CLOSE: Front passenger side door, rear RH door, rear LH door and back door*1 is closed
OPEN: Front passenger side door, rear RH door, rear LH door or back door*1 is opened |
- |
*1: for Hatchback