Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH › from 2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0259837 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 84152 1.INSPECT HEADLIGHT LEVELING SWITCH

a.
E114455C05
2.369,2.886 2.541,3.070 0.172,0.184 10 *b 1.175,0.07 1.347,0.255 0.172,0.184 10 *a
*a Component without harness connected
(Headlight Leveling Switch)
*b Battery


Check the ratio.

i.

Remove the head light leveling switch.


ii.

Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 4.


iii.

Check the ratio which is obtained by dividing the voltage between terminals 2 and 4 by the voltage between 1 and 4. The voltages must be measured using a voltmeter.

Standard Ratio:
Tester Connection Switch Condition Specified Condition
1 (B) - 4 (E)
2 (T) - 4 (E)
0 0.87 to 0.93
1 0.71 to 0.77
2 0.55 to 0.61
3 0.39 to 0.45
4 0.23 to 0.29
5 0.07 to 0.13


If the result is not as specified, replace the headlight leveling switch.



b.
E184428C06
0.104,0.052 0.354,0.344 0.25,0.292 10 false *a
*a Component without harness connected
(Headlight Leveling Switch)


Check the illumination operation.

i.

Apply battery voltage to the head light leveling switch connector.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3(ILL+)
Battery positive (-) → 4(E)
The illumination comes on


If the illumination does not illuminate, replace the headlight leveling switch.