While the alarm is armed, the EEPROM inside the body computer will remember the armed state even if the battery is disconnected, and the alarm will sound when the battery is reconnected.
If the alarm does not sound when the battery is reconnected, the alarm may not have been set, or there may be a malfunction in the body computer.
Inspect the fuses for circuits related to this system before performing the following inspection procedures.
Close all doors, the luggage compartment door*1 and the engine hood.
*1: for Sedan
Lock the doors using wireless operation or entry operation*2.
*2: w/ Smart Entry and Start System
Check that the security indicator light illuminates.
After 30 seconds have elapsed, check that the security indicator light changes from illuminated to flashing.
The illumination status of the security indicator light can be used to determine whether the theft deterrent system is set or unset.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
When any of the following conditions are met, reconnect the battery.
Driver side door is unlocked.
The engine hood is open.
Any door is opened.
The luggage compartment door is opened.*1
*1: for Sedan
Alarm sounds.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Door Control Battery) | B |
| NG (w/o Door Control Battery) | C |
A
B
C
Disconnect the battery.
Disconnect the driver side junction block assembly connectors.
| *a | Front view of wire harness connector
(to Driver Side Junction Block Assembly) |
Measure the resistance according to the value(s) in the table below.
Perform the measurement within 30 minutes after disconnecting the battery.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6O-1 - Body ground | Ignition switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG