The procedure described below is for the LH side. Use the same procedure for both the LH and RH side, unless otherwise specified.
69220
1.INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
| *a | Component without harness connected
(Front Door Outside Handle Assembly LH) |
| *b | Pushed |
| *c | Not Pushed |
| *d | Trigger Switch |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Switch Condition | Specified Condition |
|---|---|---|
| 4 (TRG-) - 1 (TRG+) | Pushed | Below 1 Ω |
| 4 (TRG-) - 1 (TRG+) | Not pushed | 10 MΩ or higher |
If the result is not as specified, replace the front door outside handle assembly LH.