Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH › from 2018.01
RM30M0E _58 Vehicle Interior _017111 THEFT DETERRENT / KEYLESS ENTRY _0087439 ENTRY LOCK AND UNLOCK SWITCH A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for the LH side. Use the same procedure for both the LH and RH side, unless otherwise specified.


PROCEDURE

Hide 69220 1.INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B488000

Install the front door outside handle assembly LH in the direction indicated by the arrow as shown in the illustration.


b.
B488001

Connect the connector.


c.
B488002

Engage the claws to close the cover.


Hide 69217D 2.INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH

a.

Apply MP grease to the sliding parts of the lock cylinder.


b.

Install the front door outside handle cover LH with lock cylinder.


c.

Using a T30 "TORX" socket wrench, tighten the screw.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


d.

Install the hole plug.


Hide 67832 3.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 67602 4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74232 5.INSTALL FRONT ARMREST BASE UPPER PANEL LH

Hide 74220 6.INSTALL FRONT ARMREST ASSEMBLY LH

Hide 67492A 7.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH