Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY(for Sedan) › from 2018.01
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092613 REAR COMBINATION LIGHT ASSEMBLY(for Sedan) A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY(for Sedan)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81562A 1.REMOVE REAR COMBINATION LIGHT GASKET

a.
E374549

Remove the rear combination light gasket.

NOTICE:
·

Be sure to remove all the traces of the old rear combination light gasket from the body.

·

Do not reuse the removed rear combination light gasket. Be sure to install a new rear combination light gasket to prevent water ingress.




Hide 81550L 2.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E374552

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and separate them as a unit.


b.
E374554

Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.


Hide 81550H 3.REMOVE TAIL AND STOP LIGHT BULB (for Bulb Type Stop Light)

a.
E375249

Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration, and separate them as a unit.


b.

Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.


Hide 81565 4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for LED Type Stop Light)

a.
E374551

Disconnect the connector to remove the rear combination light socket and wire sub-assembly.


Hide 81555 5.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for Bulb Type Stop Light)

a.
E375251

Disengage the 2 clamps to remove the rear combination light socket and wire sub-assembly.