Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
81555
1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for Bulb Type Stop Light)
Engage the 2 clamps to install the rear combination light socket and wire sub-assembly.
81565
2.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (for LED Type Stop Light)
Connect the connector to install the rear combination light socket and wire sub-assembly.
81550H
3.INSTALL TAIL AND STOP LIGHT BULB (for Bulb Type Stop Light)
Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly.
Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.
81550L
4.INSTALL REAR TURN SIGNAL LIGHT BULB
Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.
81562A
5.INSTALL REAR COMBINATION LIGHT GASKET
Install a new rear combination light gasket.
Be sure to remove all the traces of the old rear combination light gasket from the body.
Do not reuse the removed rear combination light gasket. Be sure to install a new rear combination light gasket to prevent water ingress.