Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE(for Front Side) › from 2018.01
RM30M0E _59 Vehicle Exterior _017125 WIPER / WASHER _0090080 WASHER NOZZLE(for Front Side) G

WIPER / WASHER  WASHER NOZZLE(for Front Side)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

With the ignition switch to ON, check the position that the washer fluid hits the windshield glass.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.


With the ignition switch to ON, check the position that the washer fluid hits the windshield glass.

B487195C05
1.177,1.833 1.344,1.646 false 1.323,2.281 1.521,2.083 true 1.729,3.719 1.958,3.604 false 5.792,1.719 5.875,1.875 false 5.656,1.979 5.75,2.146 true 5.219,3.531 5.448,3.417 false 3.198,0.208 3.354,0.406 0.156,0.198 10 false A 3.823,0.219 3.979,0.417 0.156,0.198 10 false A 3.302,4.146 3.458,4.344 0.156,0.198 10 false B 3.74,4.146 3.896,4.344 0.156,0.198 10 false B 1.01,1.76 1.323,1.917 0.313,0.156 10 false *a 1.146,2.219 1.458,2.375 0.313,0.156 10 false *b 1.552,3.615 1.865,3.771 0.313,0.156 10 false *c 5.885,1.875 6.198,2.031 0.313,0.156 10 false *a 5.771,2.156 6.083,2.313 0.313,0.156 10 false *b 5.49,3.313 5.802,3.469 0.313,0.156 10 false *c
*a Upper Limit *b Standard
*c Lower Limit - -


Standard Clearance
Area Measurement Area Measurement
A 153.0 mm (6.02 in.) B 8.4 mm (0.331 in.)

If the result is not as specified, replace the washer nozzle sub-assembly.