Home › Drivetrain › K411 CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2018.01
RM30M0E _52 Drivetrain _052750 K411 CVT _0254682 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K411 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  U0124  Lost Communication with Lateral Acceleration Sensor Module  


DESCRIPTION

The ECM receives signals sent from the airbag ECU assembly (yaw rate and acceleration sensor) via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding ECU or sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U0124 Lost Communication with Lateral Acceleration Sensor Module While the ignition switch is ON, there is no communication between the ECM and airbag ECU assembly (yaw rate and acceleration sensor) for 1.25 seconds (1 trip detection logic).
·

CAN communication system

·

Airbag ECU assembly (Yaw rate and acceleration sensor)

·

ECM


Does not come on DTC stored

PROCEDURE

1.CLEAR DTC AND PERFORM ROAD TEST
a.

Clear the DTCs.

Click hereDrivetrain>K411 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine and ECT > Clear DTCs
50002 234
HINT:

Write down the currently output DTCs before clearing them.



b.

Start the engine and drive the vehicle at a low speed.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT (DTC U0124)
2.CHECK DTC OUTPUT (DTC U0124)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

e.

Read the DTCs using the GTS.


Result:
Result Proceed to
DTC U0124 is not output A
DTC U0124 is output B



A

B