53141F
1.REMOVE RADIATOR COVER
Remove the 8 clips and radiator cover.
2.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Remove the 2 clips.
Remove the hood center cushion.
Disengage the 6 claws to remove the radiator grille sub-assembly.
3.REMOVE FRONT BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape as shown in the illustration.
| *1 | Pin Hold Clip |
| *a | Protective Tape |
Using a screwdriver wrapped with protective tape, disengage the 2 claws and remove the pin hold clip.
Use the same procedure for the RH side and LH side.
Remove the clip.
Use the same procedure for the RH side and LH side.
Remove the 6 screws.
Using a clip remover, remove the 2 clips.
Remove the bolt.
Disengage the 10 claws to remove the front bumper assembly.
w/ Fog Light:
Disconnect the 2 fog light assembly connectors.
w/ Daytime Running Light:
Disconnect the 2 daytime running light assembly connectors.