Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH › from 2018.01
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0092743 REAR POWER WINDOW SWITCH G

WINDOW / GLASS  REAR POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810D 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.

Check the resistance.

i.
B485018C01
1.771,1.021 1.917,0.552 true 2.115,1.115 2.479,1.115 true 2.104,1.479 2.438,1.729 true 1.354,1.49 1.042,1.74 true 0.938,1.125 1.302,1.125 true 0.146,0.146 0.458,0.344 0.313,0.198 10 false *a 1.917,0.365 2.073,0.563 0.156,0.198 10 false B 0.688,1.031 0.927,1.24 0.24,0.208 10 false SU 0.875,1.677 1.115,1.885 0.24,0.208 10 false U 2.552,1 2.792,1.208 0.24,0.208 10 false D 2.51,1.677 2.75,1.885 0.24,0.208 10 false SD
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (D) - 4 (SD) UP Below 1 Ω
2 (B) - 7 (U) Below 1 Ω
1 (D) - 4 (SD) off Below 1 Ω
7 (U) - 3 (SU) Below 1 Ω
7 (U) - 3 (SU) DOWN Below 1 Ω
1 (D) - 2 (B) Below 1 Ω


If the result is not as specified, replace the rear power window regulator switch assembly.