Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
87103B
1.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY
Remove the 3 screws and blower motor with fan sub-assembly.
88548B
2.REMOVE AIR FILTER CASE
Disengage the claw and guide to remove the air filter case.
87139D
3.REMOVE AIR REFINER ELEMENT
Remove the air refiner element.
88539
4.REMOVE NO. 1 COOLER UNIT DRAIN HOSE
Remove the No. 1 cooler unit drain hose.
87106H
5.REMOVE AIR MIX DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Disconnect the connector.
Remove the 3 screws and air mix damper servo sub-assembly.
87106N
6.REMOVE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Disconnect the connector.
Remove the 3 screws and recirculation damper servo sub-assembly.
87106N
7.REMOVE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY (for Manual Air Conditioning System)
87106J
8.REMOVE MODE DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Disconnect the connector.
Remove the 3 screws and mode damper servo sub-assembly.
88669E
9.REMOVE AIR HOSE (for Automatic Air Conditioning System)
Remove the air hose.
88897U
10.REMOVE ASPIRATOR PIPE (for Automatic Air Conditioning System)
Disengage the 2 claws and remove the aspirator pipe.
88515
11.REMOVE NO. 1 EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and No. 1 expansion valve.
| *1 | No. 1 Cooler Evaporator Sub-assembly |
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
82210K
12.REMOVE AIR CONDITIONING HARNESS ASSEMBLY (for Automatic Air Conditioning System)
for LHD:
Disengage the 5 guides and remove the air conditioning harness assembly.
for RHD:
Disengage the 5 guides and remove the air conditioning harness assembly.
88501
13.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Disengage the clamp.
| *a | Cut |
Using a knife, cut off the packing, as shown in the illustration.
Remove the 6 screws.
for LHD:
Disengage the 7 claws and remove the lower heater case.
for RHD:
Disengage the 8 claws and remove the lower heater case.
Remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.
88625
14.REMOVE NO. 1 COOLER THERMISTOR
87150B
15.REMOVE HEATER RADIATOR ASSEMBLY
for RHD:
Remove the 5 screws.
Disengage the 2 claws and 3 guides and remove the heater cover.
Remove the 2 screws.
Disengage the claw and remove the plate cover.
Remove the heater radiator assembly.