Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR › from 2018.01
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090072 ROOM TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  ROOM TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88625Q 1.INSPECT COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR

a.

Check the resistance.

i.
I109807C01
1.615,3.042 2.031,2.625 false 1.833,1.146 2.354,1.365 true 0.104,0.073 0.417,0.271 0.313,0.198 10 false *a 2.396,1.292 2.708,1.49 0.313,0.198 10 false *b 0.094,2.719 0.406,2.917 0.313,0.198 10 false *c 1.875,4.365 2.188,4.563 0.313,0.198 10 false *d 2.073,2.5 2.385,2.698 0.313,0.198 10 false *e
*a Component without harness connected
(Cooler (Room Temperature Sensor) Thermistor)
*b Sensing Portion
*c Resistance (kΩ)
*d Temperature (°C (°F))
*e Acceptable Range


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 10°C (50°F) 3.00 to 3.73 kΩ
1 - 2 15°C (59°F) 2.45 to 2.88 kΩ
1 - 2 20°C (68°F) 1.95 to 2.30 kΩ
1 - 2 25°C (77°F) 1.60 to 1.80 kΩ
1 - 2 30°C (86°F) 1.28 to 1.47 kΩ
1 - 2 35°C (95°F) 1.00 to 1.22 kΩ
1 - 2 40°C (104°F) 0.80 to 1.00 kΩ
1 - 2 45°C (113°F) 0.65 to 0.85 kΩ
1 - 2 50°C (122°F) 0.50 to 0.70 kΩ
1 - 2 55°C (131°F) 0.44 to 0.60 kΩ
1 - 2 60°C (140°F) 0.36 to 0.50 kΩ


NOTICE:
·

Even slightly touching the sensor may change the resistance value. Be sure to hold the sensor connector.

·

When measuring, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph). If the result is not as specified, replace the cooler (room temperature sensor) thermistor.