Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › from 2018.01
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0086573 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  TERMINALS OF ECU  


AIR CONDITIONING AMPLIFIER ASSEMBLY


E226604E23
3,0.115 3.333,0.344 0.333,0.229 5.135,0.115 5.469,0.344 0.333,0.229 5.229,0.156 5.406,0.344 0.177,0.188 10 false z2 3.052,0.156 3.333,0.313 0.281,0.156 10 false F3

HINT:

Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
F3-1 (IG+) - F3-14 (GND) R - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F3-4 (LIN1) - F3-14 (GND) BE - W-B LIN communication signal Ignition switch ON Pulse generation
F3-9 (PSW) - F3-14 (GND) SB - W-B Air conditioner pressure sensor signal
·

Engine running

·

Refrigerant pressure normal

·

Blower switch: LO

·

A/C switch: On


0.74 to 4.62 V
·

Engine running

·

Refrigerant pressure abnormal (less than 196 kPa [2.0 kgf/cm2, 28 psi])

·

Blower switch: LO

·

A/C switch: On


Below 0.74 V
·

Engine running

·

Refrigerant pressure abnormal (more than 3140 kPa [32.0 kgf/cm2, 455 psi])

·

Blower switch: LO

·

A/C switch: On


4.62 V or higher
F3-10 (S5-2) - F3-14 (GND) W - W-B Solar sensor power supply Ignition switch ON 4.5 to 5.5 V
F3-11 (TX+) - F3-14 (GND) V - W-B CAN communication signal Ignition switch ON Pulse generation
F3-12 (TX-) - F3-14 (GND) W - W-B CAN communication signal Ignition switch ON Pulse generation
F3-14 (GND) - Body ground W-B - Body ground Ground for main power supply Always Below 1 Ω
F3-15 (SG-1) - Body ground P - Body ground Ground for room temperature sensor Always Below 1 Ω
F3-20 (HR) - F3-14 (GND) G - W-B Blower motor relay operation signal
·

Ignition switch ON

·

Blower switch: LO


Below 1 V
·

Ignition switch ON

·

Blower switch: Off


11 to 14 V
F3-21 (B) - F3-14 (GND) GR - W-B Power source (Back-up) Always 11 to 14 V
F3-22 (BLW) - F3-14 (GND) G - W-B Blower motor speed control signal
·

Ignition switch ON

·

Blower switch: LO


Pulse generation
(See waveform 1)
F3-29 (TR) - F3-15 (SG-1) L - P Room temperature sensor signal
·

Ignition switch ON

·

Cabin temperature: 25°C (77°F)


1.8 to 2.2 V
F3-30 (S5-3) - F3-34 (SG-2) LG - L Power supply for air conditioner pressure sensor Ignition switch ON 4.75 to 5.25 V
F3-33 (TSD) - F3-14 (GND) B - W-B Solar sensor signal
·

Ignition switch ON

·

Solar sensor subjected to electric light


0.8 to 4.3 V
·

Ignition switch ON

·

Solar sensor covered with a cloth


Below 0.8 V
F3-34 (SG-2) - Body ground L - Body ground Ground for air conditioner pressure sensor Always Below 1 Ω
F3-36 (AC1) - F3-14 (GND) L - W-B Magnet clutch request signal
·

Engine running

·

Blower switch: LO

·

A/C switch off


11 to 14 V
·

Engine running

·

Blower switch: LO

·

A/C switch: On (magnet clutch on)


Below 1 V
z2-2 (BUS G) - Body ground - Ground for BUS IC Always Below 1 Ω
z2-3 (BUS) - z2-2 (BUS G) - LIN communication signal Ignition switch ON Pulse generation
z2-4 (B BUS) - z2-2 (BUS G) - Power supply for BUS IC Always 11 to 14 V
z2-5 (SGA) - Body ground - Ground for evaporator temperature sensor Always Below 1 Ω
z2-6 (TEA) - z2-5 (SGA) - Evaporator temperature sensor signal
·

Ignition switch ON

·

Evaporator temperature: 0°C (32°F)


2.0 to 2.4 V
·

Ignition switch ON

·

Evaporator temperature: 15°C (59°F)


1.4 to 1.8 V

a.
E103396N21
2.917,1.667 3.313,1.875 0.396,0.208 10 GND

Waveform 1:

Item Content
Terminal No. F3-22 (BLW) - F3-14 (GND)
Tool Setting 1 V/DIV., 50 μs./DIV.
Vehicle Condition
·

Ignition switch ON

·

Blower switch: LO





AIR CONDITIONING CONTROL ASSEMBLY


E371825E03
3.25,0.167 3.75,0.417 0.5,0.25 3.333,0.219 3.948,0.417 0.615,0.198 10 false F171

HINT:

Check from the rear of the connector while it is connected to the air conditioning control assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
F171-1 (IG+) - F171-8 (GND) G - W-B Power source (IG) Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
F171-6 (LIN1) - F171-8 (GND) BE - W-B LIN communication signal Ignition switch ON Pulse generation
F171-8 (GND) - Body ground W-B - Body ground Ground for air conditioning control assembly Always Below 1 Ω


COMBINATION METER ASSEMBLY


E270874E20
2,0.26 2.5,0.5 0.5,0.24 2.135,0.302 2.594,0.5 0.458,0.198 10 false F38

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F38-1 (B) - Body ground B - Body ground Battery Always 11 to 14 V
F38-2 (IG+) - Body ground SB - Body ground Ignition switch signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
F38-21 (EP) - Body ground W-B - Body ground Ground Always Below 1 V
F38-36 (TX1+) - F38-37 (TX1-) B - G Outside temperature signal Ignition switch ON 11 to 14 V