Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2018.01
RM30M0E _57 Power Source / Network _017152 NETWORKING _0084784 CAN COMMUNICATION SYSTEM U

NETWORKING  CAN COMMUNICATION SYSTEM  FAIL-SAFE CHART  


FAIL-SAFE FUNCTION


a.

When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for each system operates to prevent those systems from malfunctioning.


b.

The following table shows the effects on each system when communication is impossible. (For further details, see the pages for each system.)

Function Control Master System Related Fail-safe Operation Driver Detectable DTC Detection
(ECU that stored DTC)
Vehicle Stability Control/Traction Control
·

Suppresses vehicle instability, such as sliding sideways when cornering and wheel slippage when accelerating from rest.


Brake actuator assembly
·

ECM

·

Steering sensor

·

Airbag ECU assembly


·

During control: After ending back up control (stabilizing the vehicle), the system changes to normal braking and prohibits control.

·

Not during control: Control cannot start.


·

ABS warning light illuminates.

·

Slip indicator light illuminates.


·

U0073

·

U0100

·

U0124

·

U0126


(Brake actuator assembly)
Hill-start Assist Control
·

(Maintains the brake oil pressure for 2 seconds when the brake pedal is depressed further.)


Brake actuator assembly
·

ECM

·

Steering sensor

·

Airbag sensor assembly


·

During control: After ending back up control (pressure reduction control), the system changes to normal braking and prohibits control.

·

Not during control: Control cannot start.


·

ABS warning light illuminates.

·

Slip indicator light illuminates.


·

U0073

·

U0100

·

U0124

·

U0126


(Brake actuator assembly)
Air Conditioning Control
·

Corrects engine speed, such as for idle up.

·

Controls outlet air temperature, outlet mode change and airflow volume based on engine coolant temperature signal.

·

Corrects engine coolant temperature map and changes compressor lock judgment value.


Air conditioning amplifier assembly ECM
·

Control is performed based on default coolant temperature of 80°C (176°F).

·

Control is performed based on engine model (differs between vehicle models).


- U0100
(Air conditioning amplifier assembly)
Compressor Control
·

Determines whether the compressor is locked using engine speed information.


Air conditioning amplifier assembly ECM Control is performed based on default engine speed of 0 rpm. - U0100
(Air conditioning amplifier assembly)
Ambient Temperature Correction Control
·

Switches air conditioning system operation condition and corrects value of displayed ambient temperature according to vehicle speed signal.


Air conditioning amplifier assembly Combination meter assembly Control is performed based on default vehicle speed of 0 km/h (0 mph).
·

Correction level for displayed ambient temperature declines.

·

Correction level for outlet airflow declines.


U0155
(Air conditioning amplifier assembly)
Entry Function
·

Entry lock/unlock and back door unlatch

·

Warning


Certification ECU (Smart key ECU assembly)
·

Certification ECU (smart key ECU assembly)

·

ECM


Entry unlock is performed again.
·

Entry lock/unlock or back door unlatch does not operate.

·

Warning functions (Key confinement, Key not in vehicle, Key reminder etc.) do not operate, Key confinement prevention control does not operate.


·

U0100

·

U0155


(Certification ECU (smart key ECU assembly))
Engine Switch Backlighting Control
·

Turns on/off engine switch illumination linked with interior lights etc.


Certification ECU (smart key ECU assembly)
·

Certification ECU (smart key ECU assembly)

·

Combination meter assembly


·

When the engine switch backlight is illuminated as the DOME light illuminates:

turn off.


·

When the engine switch backlight is not illuminated:

Does not illuminate.

·

When the engine switch backlight is illuminated as the DOME light illuminates:

Does not turn off.


-
Vehicle Speed Display Combination meter assembly Brake actuator assembly Control is performed based on signal value of 0. The speedometer displays 0 km/h (0 mph). U0129
(Combination meter assembly)
Tachometer Combination meter assembly ECM Control is performed based on signal value of 0. The tachometer displays 0 rpm. U0100
(Combination meter assembly)
Brake Warning
·

Brake Warning light control.


Combination meter assembly Brake actuator assembly The brake warning light illuminates. The brake warning light illuminates. -
Seat Belt Warning
·

Seat Belt Warning light control.


Combination meter assembly Brake actuator assembly Control is performed based on signal value of 0. The seat belt warning light turns off. -
Airbag Warning
·

Airbag warning light control.


Combination meter assembly Airbag ECU assembly Control is performed based on signal value of "Active". Airbag warning light illuminates. U0151
(Combination meter assembly)
Engine Coolant Temperature Warning
·

Engine Coolant Temperature Warning light control.


Combination meter assembly ECM Engine Coolant Temperature Warning light illuminates. Engine Coolant Temperature Warning light illuminates. -
Electronic Power Steering Warning
·

Electronic Power Steering Warning light control.


Combination meter assembly Power steering ECU assembly Electronic Power Steering Warning light illuminates. Electronic Power Steering Warning light illuminates. U0131
(Combination meter assembly)
SLIP Warning
·

SLIP Warning light control.


Combination meter assembly Brake actuator assembly SLIP Warning light illuminates. SLIP Warning light illuminates. -
ABS Warning
·

ABS Warning light control.


Combination meter assembly Brake actuator assembly ABS Warning light illuminates. ABS Warning light illuminates. -
Electronic Power Steering System
·

Calculates the current to be used for the steering assist according to the torque sensor value and vehicle speed, and then operates the motor.


Power steering ECU assembly
·

ECM

·

Brake actuator assembly

·

Steering sensor


·

Electronic power steering does not operate.

·

Power steering assist is temporarily limited.

·

The steering feel becomes worse (compensation control using the steering angle is stopped).


The electronic power steering warning light illuminates.
·

U0100

·

U0129


(Power steering ECU assembly)
VDIMα System
·

Calculates current to be used for steering assist according to commanded value from VSC, and then operates motor.


·

Brake actuator assembly

·

Power steering ECU assembly


Brake actuator assembly VDIMα control is stopped. - U0129
(Power steering ECU assembly)
αB Control
(Performs assist to prevent sliding sideways.)
·

Brake actuator assembly

·

Power steering ECU assembly


Brake actuator assembly During αB control, if the CAN communication data becomes invalid, control stops. The electronic power steering warning light illuminates. U0129
(Power steering ECU assembly)
Steering Assist Calculation
(Changes the assist force according to the vehicle speed.)
Power steering ECU assembly Brake actuator assembly Assist is temporarily limited. The electronic power steering warning light illuminates. U0129
(Power steering ECU assembly)
Assist Start Judgment
(Permits assist only when the engine is running or while driving the vehicle.)
Power steering ECU assembly Brake actuator assembly Assist is temporarily limited. The electronic power steering warning light illuminates. U0129
(Power steering ECU assembly)
Steering Center Point Learning
(Learns the steering wheel center point.)
Power steering ECU assembly
·

Brake actuator assembly

·

Airbag ECU assembly

·

Steering sensor


The steering wheel center point is not learned if there is a problem with CAN communication. The electronic power steering warning light illuminates. U0129
(Power steering ECU assembly)
Compensation Control
(Performs assist according to the vehicle speed for various compensation controls.)
Power steering ECU assembly Brake actuator assembly Assist is temporarily limited. The electronic power steering warning light illuminates. U0129
(Power steering ECU assembly)