| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1531 | ECU Malfunction | ECU internal malfunction
(CPU malfunction) |
Power steering ECU assembly | EPS warning light: Comes on | Ignition switch ON again | - |
| C1532 | ECU Malfunction | ECU internal malfunction (Peripheral circuit malfunction) | Power steering ECU assembly | EPS warning light: Comes on | Ignition switch ON again | - |
| C1533 | Temperature Sensor Circuit is Low or High | ECU internal malfunction
(Substrate temperature sensor malfunction) |
Power steering ECU assembly | EPS warning light: Comes on | Ignition switch ON again and after normal confirmation | - |
| C1534 | EEPROM | ECU internal malfunction
(EEPROM error) |
Power steering ECU assembly | EPS warning light: Comes on | Ignition switch ON again | - |
| C1535 | ECU Malfunction | ECU internal malfunction (Steering wheel location data error) | Power steering ECU assembly | EPS warning light: Comes on | Ignition switch ON again | - |
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Clear the DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs other than C1531, C1532, C1533, C1534 or C1535 are not output. | A |
| DTCs other than C1531, C1532, C1533, C1534 or C1535 are output. | B |
A
B