If a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1552 | PIG Power Supply Voltage | PIG power source circuit malfunction | ·
EPS fuse ·
PIG power source circuit ·
Power steering ECU assembly |
EPS warning light: Comes on | After normal confirmation | - |
| C1554 | Power Supply Relay Failure | Power source relay circuit malfunction | ·
EPS fuse ·
PIG power source circuit ·
Power steering ECU assembly |
EPS warning light: Comes on | Ignition switch ON again | - |
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the connection condition of the power steering ECU assembly connectors.
The power steering ECU assembly connectors are securely connected.
Check that the ground wire is securely installed with the bolt.
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>INSTALLATION
The ground wire is securely installed with the bolt.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Data List.
| Tester Display |
|---|
| PIG Power Supply |
Select the item "PIG Power Supply" in the Data List and read the value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PIG Power Supply | Power source voltage to active motor | Min.: 0.0000 V
Max.: 20.1531 V |
11 to 14 V | Always |
The normal condition value is displayed on the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Disconnect the power steering ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F11-1 (PIG) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Disconnect the power steering ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F11-2 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG