If the power steering ECU assembly determines that the motor power source voltage and the IG voltage are not within the specified range, it stops the power assist as a fail-safe function.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1553 | PIG Power Supply Overvoltage | ·
PIG power source overvoltage ·
IG power source overvoltage |
·
EPS fuse ·
EPS-IG fuse ·
IG and PIG power source circuits ·
Power steering ECU assembly |
EPS warning light: Comes on | After normal confirmation | - |
DTC will be output when conditions for either of the patterns in the table above are met.
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the power steering ECU assembly connectors.
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F12-1 (IG) - F11-2 (PGND) | Ignition switch ON | 11 to 14 V |
| F11-1 (PIG) - F11-2 (PGND) | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG