| Component | Outline |
|---|---|
| Engine switch
·
Transponder key amplifier |
·
Turns on the power and starts the engine. ·
Contains a built-in transponder key amplifier to start the engine when the electrical key transmitter sub-assembly does not operate properly due to a depleted battery or wave interference. |
| Certification ECU (smart key ECU assembly) | ·
Changes the power source mode by operating the ACC and IG relays. ·
Controls starting by operating the starter relay assembly. ·
Performs key verification. ·
Controls the No. 1 Indoor electrical key antenna assembly (instrument panel) or No. 2 Indoor electrical key antenna assembly (rear floor). ·
Outputs entry door lock/unlock commands. ·
Outputs steering lock ECU (steering lock actuator assembly) lock/unlock command signals. ·
Outputs immobiliser set/unset commands. ·
Forms the entry detection area. |
| ECM | Outputs a signal indicating that the engine has started to the certification ECU (smart key ECU assembly) when starting the engine. |
| Steering lock ECU (steering lock actuator assembly) | ·
Receives command signals from the certification ECU (smart key ECU assembly) and activates the steering lock actuator assembly. ·
Records codes for smart verification. |
| Combination meter assembly | ·
Operates various warnings (blinking or illumination of the smart warning light sounding of the buzzer in the combination meter) according to the command signals from the certification ECU (smart key ECU assembly). ·
Displays information or operates LED when the smart entry and start system has a malfunction. ·
Outputs a vehicle speed signal to the certification ECU (smart key ECU assembly). ·
Blinks the hazard warning lights during answer back according to body computer control (answer back function). |
| IG, ACC relay | Turns on/off according to the certification ECU (smart key ECU assembly) and provides power to each system. |
| Stop light switch assembly*1 | Detects that the brake pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly). |
| Clutch start switch assembly*2 | Detects that the clutch pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly). |
| Park/neutral position switch*1 | Outputs the shift position to the certification ECU (smart key ECU assembly). |
| Shift lock control unit assembly*1 | Outputs a shift lock control ECU signal to the certification ECU (smart key ECU assembly). |
| No. 1 Indoor electrical key antenna assembly (instrument panel)
No. 1 Indoor electrical key antenna assembly (rear floor) |
Sends the request code from the certification ECU (smart key ECU assembly) and forms the vehicle interior detection area. |
| Door control receiver | Receives the smart entry and start system code/wireless code sent from the electrical key transmitter sub-assembly and sends it to the certification ECU (smart key ECU assembly). |
| Electrical key transmitter sub-assembly | Sends the ID code upon receiving a request signal. |
*1: for CVT
*2: for Manual Transaxle