Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM › from 2018.01
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0089807 KEY REMINDER WARNING SYSTEM U

DOOR LOCK  KEY REMINDER WARNING SYSTEM  TERMINALS OF ECU  


CHECK COMBINATION METER ASSEMBLY


a.

Disconnect the F38 combination meter assembly connector.

E271604E01
3.365,0.271 3.833,0.521 0.469,0.25 3.479,0.313 3.813,0.49 0.333,0.177 10 false F38


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
F38-1 (B) - Body ground B - Body ground Battery power supply Always 11 to 14 V
F38-2 (IG+) - Body ground SB - Body ground IG power supply Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F38-21 (EP) - Body ground W-B - Body ground Ground Always Below 1 Ω
F38-30 (DCTY) - Body ground BR - Body ground Driver door courtesy light switch input Driver door open*1 Below 1 V
Driver door closed*1 Pulse generation
Map light switch DOOR position and driver door open*2 Below 1 V
Map light switch DOOR position and driver door closed*2 11 to 14 V
F38-27 (KSW) - Body ground SB - Body ground Unlock warning switch signal No key in ignition key cylinder 10 kΩ or higher
Key in ignition key cylinder Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.

*1: w/ Power Door Lock

*2: w/o Power Door Lock