CHECK ILLUMINATED ENTRY SYSTEM OPERATION (w/ Power Door Lock)
The lights controlled by the illuminated entry system are as follows.
Engine Switch*1
Map Light Assembly (When switch is in DOOR position)
Room Light Assembly (When switch is in DOOR position)
*1: w/ Smart Entry and Start System
Check the map light assembly and room light assembly.
The operation and conditions are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | Any door is opened when all doors are closed. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions are met, the lights illuminate for 15 seconds, and then fade out:
·
The driver door is unlocked when the ignition switch is off with all doors closed and locked. ·
The ignition switch is turned from ON to off when all doors are closed. ·
All doors are closed after any door is opened when the ignition switch is off. |
| Fade out immediately | When any of the following conditions are met, the lights fade out immediately:
·
The ignition switch is turned from off to ON when all doors are closed. ·
The driver door is locked when the ignition switch is off, all doors are closed and the driver door is unlocked. |
Check the engine switch.(w/ Smart Entry and Start System)
The operation and conditions are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | ·
Any door is opened when all doors are closed. ·
The headlight dimmer switch is in the tail position. ·
The engine switch is on (ACC or IG). |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions are met, the lights illuminate for 15 seconds, and then fade out:
·
The driver door is unlocked when the engine switch is off with all doors closed and locked. ·
The engine switch is turned from on (IG) to off when all doors are closed. ·
All doors are closed after any door is opened when the engine switch is off. ·
With the engine switch off, all doors closed and any of the doors unlocked, the headlight dimmer switch is moved from the tail position to off.*1 |
| Fade out immediately | When any of the following conditions are met, the lights fade out immediately:
·
The engine switch is turned from on (ACC) to off, or the engine is started, when all doors are closed. ·
The engine switch is turned from on (IG) to the engine started, when all doors are closed. ·
The driver door is locked when the engine switch is off, all doors are closed and the driver door is unlocked. ·
With all doors locked, the headlight dimmer switch is moved from the tail position to off, and then all doors are closed. ·
With all doors closed, the headlight dimmer switch is moved from the tail position to off, and then all doors are locked. |
*1: However, when all doors are locked within 15 seconds, the lights that operate turn off.
CHECK BATTERY SAVING FUNCTION (w/ Power Door Lock)
The lights controlled by the battery saving function are as follows:
Engine Switch*1
Map Light Assembly (When switch is in DOOR position)
Room Light Assembly (When switch is in DOOR position)
*1: w/ Smart Entry and Start System
The operation and conditions are described below.
| Operation | Condition |
|---|---|
| The lights are turned off | When the doors remain in the same condition for 20 minutes and the engine switch is off, the illumination turns off.*1 |
| When the doors remain in the same condition for 20 minutes and the key is not in the ignition key cylinder, the illumination turns off.*2 |
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System