1.INSPECT VSC OFF SWITCH
Check the resistance.
| *a | Component without harness connected
(VSC OFF Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (+) - 3 (E) | Switch pushed | Below 1 Ω |
| 6 (+) - 3 (E) | Switch not pushed | 10 kΩ or higher |
Check that the illumination illuminates.
Apply battery voltage to the VSC OFF switch and check that the switch illumination illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
Illuminates |
If the result is not as specified, replace the VSC OFF switch.