Home › Engine / Hybrid System › 2NR-FE STARTING › IGNITION SWITCH › from 2018.01
RM30M0E _51 Engine / Hybrid System _053950 2NR-FE STARTING _0262389 IGNITION SWITCH A

2NR-FE STARTING  IGNITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84450 1.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY

a.
A282698

Engage the 2 claws to install the ignition or starter switch assembly to the ignition switch lock cylinder and key set.

NOTICE:
·

Perform this operation after situating the ignition switch lock cylinder and key set in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.

·

Do not turn the ignition switch lock cylinder and key set sideways or downward because doing so might release the ignition switch lock cylinder and key set's component parts.




Hide 69057A 2.INSTALL IGNITION SWITCH LOCK CYLINDER AND KEY SET

Hide 3.INSTALL STEERING COLUMN ASSEMBLY