Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER(for Sedan) › from 2018.01
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0089075 NOISE FILTER(for Sedan) A

AUDIO / VIDEO  NOISE FILTER(for Sedan)  INSTALLATION  


PROCEDURE

Hide 86011R 1.INSTALL RADIO SETTING CONDENSER

a.
E183101

Engage the claw and install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.




b.
E221975

Engage the 3 claws and install the new terminal cover with wire harness and a new condenser.

NOTICE:
·

Do not use excessive force when inserting the terminal cover into the condenser.

·

If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.




c.

Engage the clamp and temporarily install a new radio setting condenser with wire harness.


d.

Install the new radio setting condenser with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 73370 2.INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH