Home › Vehicle Exterior › BODY PANEL › FRONT SIDE MEMBER › 2020.03–2020.09
BM36W0E _01 Vehicle Exterior _088117 BODY PANEL _0420569 FRONT SIDE MEMBER F

BODY PANEL  FRONT SIDE MEMBER  ASSEMBLY REPLACEMENT  


K156365

With the radiator side support assembly and front fender apron assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points

K156200C01
0.167,0.177 0.479,0.333 0.313,0.156 10 false *A
*A LH - -


K156201C01
0.167,0.177 0.479,0.333 0.313,0.156 10 false *A
*A RH - -


K156198


INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld
K108830

Fillet Weld

a.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


b.

Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.

K156202C02
3.25,1 3.667,0.583 3.667,0.583 3.833,0.583 false 5.167,4.083 5,4.083 5,4.083 4.5,3.583 false 0.167,0.167 0.479,0.323 0.313,0.156 10 false *A 3.875,0.521 4.188,0.677 0.313,0.156 10 false *1 5.208,4.01 5.521,4.167 0.313,0.156 10 false *2 0.219,1.125 0.531,1.281 0.313,0.156 10 false *a 2.031,1.958 2.344,2.115 0.313,0.156 10 false *a
*A LH - -
*1 FRONT SIDE MEMBER SUB-ASSEMBLY OUTER *2 FRONT SIDE MEMBER SUB-ASSEMBLY INNER
*a 20 mm (0.79 in.) - -


K156203C01
2,2.083 2.167,2.083 2.167,2.083 2.75,1.5 false 2.875,3.927 3.042,3.927 3.042,3.927 3.625,3.427 false 0.167,0.167 0.479,0.323 0.313,0.156 10 false *A 2.688,3.875 3,4.031 0.313,0.156 10 false *1 1.813,2.021 2.125,2.177 0.313,0.156 10 false *2
*A RH - -
*1 FRONT SIDE MEMBER SUB-ASSEMBLY OUTER *2 FRONT SIDE MEMBER SUB-ASSEMBLY INNER


K156337C01
0,0 0,0 false

K156339C01
0.167,0.167 0.479,0.323 0.313,0.156 10 false *A
*A LH - -


K156340C01
0.167,0.167 0.479,0.323 0.313,0.156 10 false *A
*A RH - -



c.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)


d.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.