With the quarter panel cut and join replacement sections (small areas) removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut and Join Location |
Carefully cut the step plate sub-assembly lower so as not to damage A.
| *1 | STEP PLATE SUB-ASSEMBLY LOWER | - | - |
| *a | 40 mm (1.57 in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Plug Weld |
|
Cut and Join Location |
|
Butt Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
If the entire supply part is not needed, remove the part of the supply part that is needed.
| *1 | STEP PLATE SUB-ASSEMBLY LOWER | - | - |
| *a | 90 mm (3.54 in.) | - | - |
Weld the step plate sub-assembly lower to the vehicle side.
| *1 | STEP PLATE SUB-ASSEMBLY LOWER | - | - |
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.