Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *A | for HV Model | - | - |
| *1 | SYMBOL EMBLEM | *2 | BACK DOOR ORNAMENT |
| *3 | NO. 1 BACK DOOR NAME PLATE | *4 | NO. 2 BACK DOOR NAME PLATE |
| ● | Non-reusable part | - | - |
| *A | for HV Model | *B | for LH Side |
| *C | for RH Side | - | - |
| *1 | SIDE PANEL EMBLEM | - | - |
| ● | Non-reusable part | - | - |
SIDE PANEL EMBLEM
for LH Side:
| *a | Reference Values | *b | End of R |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 227.4 mm (8.95 in.) | B | 161.5 mm (6.36 in.) |
| C | 29.2 mm (1.15 in.) | D | 148.6 mm (5.85 in.) |
for RH Side:
| *a | Reference Values | *b | End of R |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 145.9 mm (5.74 in.) | B | 25.5 mm (1.00 in.) |
| C | 157.3 mm (6.19 in.) | D | 226.7 mm (8.93 in.) |
NO. 2 BACK DOOR NAME PLATE
| *a | location pin |
NO. 1 BACK DOOR NAME PLATE
| *a | Reference Values | *b | Edge of Back Door Panel |
| *c | End of R | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 45.4 mm (1.787 in.) | B | 148.2 mm (5.835 in.) |
| C | 19.6 mm (0.772 in.) | D | 18.3 mm (0.720 in.) |
SYMBOL EMBLEM