With the rocker rear panel cut and join replacement and back door opening trough cut and join replacement removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut and Join Location |
Remove the A.
A is reused.
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
|
Adhesive | - | - |
Remove the quarter wheel house panel outer.
| *a | 100 mm (3.94 in.) | *b | 45 mm (1.77 in.) |
| *1 | QUARTER WHEEL HOUSE PANEL OUTER | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
|
Butt Weld |
|
Assembly Mark |
For positioning of the new parts, align the installation standard holes of the outer panel and the inner panel.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).
Do not apply adhesive around the plug welding points.
Minimize squeeze out in plug welding areas.
|
Adhesive | - | - |
Weld the quarter wheel house panel outer to the vehicle side.
| *1 | QUARTER WHEEL HOUSE PANEL OUTER | - | - |
Weld the A to the vehicle side.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.