Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Radiator Support Lower Standard Hole | φ18 (0.71) |
| B, b | Front Suspension Crossmember Installation Nut | M12 (0.47) |
| C, c | Front Side Inner Member Standard Hole | φ18 (0.71) |
| D, d | Front Suspension Crossmember Installation Nut | M12 (0.47) |
| E, e | Front Spring Support Standard Hole | φ11 (0.43) |
| F, f | Torque Front Box Standard Hole | φ25 (0.98) |
| G, g | Front Suspension Crossmember Brace Installation Nut | M12 (0.47) |
| H, h | Front Side Inner Rear Member Standard Hole | φ18 (0.71) |
| J, j | Front Floor Under Reinforcement Standard Hole | φ15 (0.59) |
| K, k | Rear Floor Side Front Member Standard Hole | φ18 (0.71) |
| L, l | Rear Suspension Lower Brace Installation Nut | M8 (0.31) |
| M, m | Trailing Arm Installation Hole | φ15 (0.59) |
| N, n | Rear Spring Plate Standard Hole | φ10 (0.39) |
| O, o | Rear Shock Absorber Installation Hole | φ24.5 (0.96) |
| P, p | Rear Floor Side Front Member Standard Hole | φ18 (0.71) |
| Wheel Base | 2550 mm (100.39 in.) |
| *a | mm
(in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |