With the radiator side support assembly and front fender front apron assembly removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut and Join Location |
Carefully cut the front side member sub-assembly inner so as not to damage A.
| *A | LH | - | - |
| *1 | FRONT SIDE MEMBER SUB-ASSEMBLY INNER | - | - |
| *a | 170 mm (6.69 in.) | - | - |
| *A | LH | - | - |
| *a | 50 mm (1.97 in.) | - | - |
| *A | RH | - | - |
| *a | 80 mm (3.15 in.) | - | - |
| *A | RH | - | - |
| *a | 50 mm (1.97 in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Butt Weld |
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
| *A | LH | - | - |
| *1 | FRONT SIDE MEMBER SUB-ASSEMBLY INNER | - | - |
| *A | LH | - | - |
| *1 | FRONT SIDE MEMBER SUB-ASSEMBLY OUTER | - | - |
| *A | RH | - | - |
| *1 | FRONT SIDE MEMBER SUB-ASSEMBLY INNER | - | - |
| *A | RH | - | - |
| *1 | FRONT SIDE MEMBER SUB-ASSEMBLY OUTER | - | - |
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.