Home › Vehicle Exterior › BODY PANEL › BODY LOWER BACK PANEL (for TMC Made 5 Door) › from 2020.09
BM36W0E _01 Vehicle Exterior _088117 BODY PANEL _0449296 BODY LOWER BACK PANEL(for TMC Made 5 Door) F

BODY PANEL  BODY LOWER BACK PANEL(for TMC Made 5 Door)  ASSEMBLY REPLACEMENT  


K156380

REMOVAL


Symbol Meaning
K108818

Remove Weld Points

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K155954C01
0,0 0,0 false
K108837

Adhesive - -


K155955

K155956C01
0.104,0.104 0.417,0.302 0.313,0.198 10 false *A
*A LH Side - -


K155957C01
0.104,0.104 0.417,0.302 0.313,0.198 10 false *A
*A RH Side - -




INSTALLATION


Symbol Meaning
K108823

Plug Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


c.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



K155954C02
0,0 0,0 false
K108837

Adhesive - -


K155958C01
3.417,1.5 3.583,1.5 3.583,1.5 3.833,1.917 false 3.25,1.427 3.563,1.583 0.313,0.156 10 false *1
*1 BODY LOWER BACK PANEL SUB-ASSEMBLY - -


K155959C02
6.167,2.917 7,3.167 0.833,0.25 6.583,2.917 6.583,2.583 false 0.104,0.104 0.417,0.302 0.313,0.198 10 false *A 6.281,2.958 6.99,3.177 0.708,0.219 10 false 12 (122, 9)
*A LH Side - -
V100146

N*m (kgf*cm, ft.*lbf): Specified torque - -


K155960C02
3.583,2.917 4.417,3.167 0.833,0.25 4,2.917 4,2.583 false 0.104,0.104 0.417,0.302 0.313,0.198 10 false *A 3.698,2.969 4.448,3.219 0.75,0.25 10 false 12 (122, 9)
*A RH Side - -
V100146

N*m (kgf*cm, ft.*lbf): Specified torque - -



d.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting /coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.