CONSTRUCTION
For gasoline models, a vacuum pump assembly has been provided.
Due to fuel economy improvements and mechanisms to rapidly warm the catalytic converter immediately after engine start, the M15A-FKS engine is unable to derive sufficient vacuum pressure from the intake system. For this reason, the vacuum pump assembly generates the vacuum necessary for the brake booster assembly to perform boosting.
The vacuum pump assembly is composed of an elliptically-shaped housing, a rotor and a vane. By using a single vane, when compared to a pump with multiple blades, the pumping volume within the housing is larger so that pumping ability is improved, and the reduced diameter rotor also achieves reduced weight.
The vacuum pump assembly is installed to the cylinder head sub-assembly, and is driven by the camshaft.
| *1 | Brake Booster Assembly | *2 | Vacuum Pump Assembly |
| *3 | Exhaust Camshaft | *4 | Rotor |
| *5 | Housing | *6 | Vane |
| *a | A-A Cross Section | *b | Inlet |
| *c | Outlet | - | - |
OPERATION
As the vane slides up and down through the channel in the rotor, it rotates along the inner wall of the housing. As the housing is elliptical, the volume of each of the 2 chambers partitioned by the vane changes as the vane rotates.
Labeling the 2 chambers partitioned by the vane as chamber A and chamber B, the rotation of the vane causes the volume of chamber A to decrease, and air is expelled through the outlet. Conversely, the volume of chamber B increases and air is sucked out into the pump through the inlet. The vacuum pump operates by repeating this process.
| *1 | Rotor | *2 | Vane |
| *a | Inlet | *b | Outlet |
| *c | Chamber A | *d | Chamber B |
| *e | Chamber A (Volume: Decreases) | *f | Chamber B (Volume: Increases) |