Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › SFI SYSTEM
NM36W0E _51 Engine / Hybrid System _088518 M15A-FXE ENGINE CONTROL _0421733 SFI SYSTEM CO CONTROL F

M15A-FXE ENGINE CONTROL  SFI SYSTEM  CONTROL  SEQUENTIAL MULTIPORT FUEL INJECTION (SFI) CONTROL  


FUNCTION


a.

EFI-L, which uses an intake mass air flow meter sub-assembly to detect intake air volume and subsequently control fuel injection volume, is used.


b.

Synchronous injection timing (1 injection per cylinder for every 2 crankshaft rotations) is used.


c.

There are 2 fuel injection modes, a synchronous injection and asynchronous injection. In synchronous injection, the basic injection duration is corrected based on signals from each sensor to always inject fuel at the same position. In asynchronous injection, fuel is injected at the point the injection request is detected according to signals from each sensor regardless of the crankshaft angle. In addition, to protect the engine and improve fuel efficiency, a fuel cut that stops fuel injections will be implemented according to the operating conditions.

W145171E01
0.219,0.26 2.865,0.521 2.646,0.26 10 false Intake Mass Air Flow Meter Sub-assembly 0.302,0.615 2.208,0.823 1.906,0.208 10 false Intake Air Temperature Sensor 0.219,1.198 1.698,1.406 1.479,0.208 10 false Crank Position Sensor 0.219,1.76 2.354,1.958 2.135,0.198 10 false Camshaft Position Sensor (Intake) 0.208,2.313 2.521,2.51 2.313,0.198 10 false Camshaft Position Sensor (Exhaust) 0.229,2.885 2.76,3.104 2.531,0.219 10 false Air Fuel Ratio Sensor (Bank 1, Sensor 1) 0.24,3.427 3.146,3.635 2.906,0.208 10 false No. 2 Air Fuel Ratio Sensor (Bank 1, Sensor 2) 0.219,4 2.5,4.219 2.281,0.219 10 false Engine Coolant Temperature Sensor 0.229,4.583 1.76,4.771 1.531,0.188 10 false Throttle Position Sensor 0.198,5.177 2.771,5.406 2.573,0.229 10 false Fuel Pressure Sensor 0.198,5.719 2.875,5.948 2.677,0.229 10 false E.F.I. Vacuum Sensor Assembly 4.281,3.302 4.688,3.49 0.406,0.188 10 false ECM 5.667,1.521 6.854,2.083 1.188,0.563 10 false Fuel Injector Assembly 0.531,7.375 3.208,7.604 2.677,0.229 10 false : CAN communication line 5.542,4.188 6.948,4.635 1.406,0.448 10 false Hybrid Vehicle Control ECU


d.

Fuel Cut

i.

When the engine speed exceeds the specified value, fuel injection is stopped to prevent over-revving.

Engine Speed for Fuel-cut at High Revs
Engine speed (rpm) 5800 or more