Home › Engine / Hybrid System › 1KR-FE (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › from 2020.07
NM36W0E _51 Engine / Hybrid System _091269 1KR-FE EMISSION CONTROL _0432779 EMISSION CONTROL SYSTEM GE GENERAL F

1KR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

An evaporative emission control, which regulates the purge flow of evaporative emission (HC) into the canister in accordance with the engine conditions, is used.


b.

The ECM performs the air fuel ratio feedback control based on signals from the heated oxygen sensor, and controls the fuel injection amount so that the air fuel ratio comes close to the stoichiometric air fuel ratio at which the highest purifying efficiency of CO, HC and NOx is obtained.


c.

An heated oxygen sensor heater control, which maintain the temperature of the respective sensors at an appropriate level, are used, to improve the detection accuracy of oxygen concentration in exhaust gas.


d.

A blowby gas ventilation system, which efficiently ventilates blowby gas containing HC from the crankcase, is used.


e.

An EGR (Exhaust Gas Recirculation) control, which reduces the combustion temperature by recirculation of exhaust gas and also reduces NOx emissions and improves fuel economy, is used.


f.

A three-way catalytic converter is used on the exhaust manifold and front exhaust pipe assembly to achieve low emissions.*1


g.

A three-way catalytic converter is used on the exhaust manifold to achieve low emissions.*2


h.

A Gasoline Particulate Filter (GPF) system is used to purify Particulate Matter (PM) contained in exhaust gas.*2

*1: Models without Gasoline Particulate Filter (GPF) System

*2: Models with GPF System