CONSTRUCTION
The VVT-i controllers (camshaft timing sprocket assembly and camshaft timing exhaust gear assembly) consist of an outer housing that is driven by the timing chain sprocket, and a vane that is coupled to the camshaft.
The camshaft timing sprocket assembly uses 3 vanes.
The camshaft timing exhaust gear assembly uses 4 vanes.
The oil pressure sent from the advanced or retarded side path at the intake camshaft (camshaft) and exhaust camshaft (No. 2 camshaft) causes rotation in the VVT-i controller vane circumferential direction to vary the intake and exhaust valve timing continuously.
When the engine is stopped, a lock pin locks the intake camshaft (camshaft) at the most retarded position and the exhaust camshaft (No. 2 camshaft) at the most advanced position, to ensure that the engine starts properly.
An advance assist spring is provided on the camshaft timing exhaust gear assembly. This spring applies torque in the advance direction when the engine is stopped, thus ensuring the engagement of the lock pin.
| *1 | Housing | *2 | Lock Pin |
| *3 | Vane | *4 | Intake Camshaft (Camshaft) |
| *a | Lock Pin Operation | *b | Engine Operating |
| *c | Engine Stopped | - | - |
|
Oil Pressure | - | - |
| *1 | Housing | *2 | Lock Pin |
| *3 | Exhaust Camshaft (No. 2 Camshaft) | *4 | Vane |
| *5 | Advance Assist Spring | - | - |
OPERATION
When the camshaft timing oil control valve assembly is operated as illustrated below by the advance signal from the ECM, the resultant oil pressure is applied to the timing advance side vane chamber to rotate the camshaft in the timing advance direction.
| *1 | Vane | - | - |
| *a | Rotational Direction | *b | In |
| *c | Drain | *d | Oil Pressure |
| *e | from ECM | - | - |
| *1 | Vane | - | - |
| *a | Rotational Direction | *b | In |
| *c | Drain | *d | Oil Pressure |
| *e | from ECM | - | - |
When the camshaft timing oil control valve assembly is operated as illustrated below by the retard signal from the ECM, the resultant oil pressure is applied to the timing retard side vane chamber to rotate the camshaft in the timing retard direction.
| *1 | Vane | - | - |
| *a | Rotational Direction | *b | Drain |
| *c | In | *d | Oil Pressure |
| *e | from ECM | - | - |
| *1 | Vane | - | - |
| *a | Rotational Direction | *b | Drain |
| *c | In | *d | Oil Pressure |
| *e | from ECM | - | - |
After reaching the target timing, the valve timing is held by keeping the camshaft timing oil control valve assembly in the neutral position unless the traveling state changes. This adjusts the valve timing at the desired target position and prevents the engine oil from running out when it is unnecessary.